Brady THT-BP Precision Manuel de l'opérateur télécharger pdf (Page 72)

72 Transfer Printer THT-BP Precision

9. Test Options

Status Print

When selecting the "Status print" option, an internal test sample will be printed

which contains a variety of information about the configuration of the printer as

well as status of the printer.

To prepare for a status print, load media (labels, continuous paper) and a

transfer ribbon (if applicable), which extends over the entire print width of the

printer.

NOTICE !

With "Status print", the printer will not sense any label gaps, and will print

non-stop, producing output with an approximate length of 10.3" (260

mm). Continuous paper works best for the prints, otherwise, a regular

sheet of paper cut to a width of 4.7 in (120 mm) can be used in thermal

transfer mode.

1. Switch from "Online" mode to the Offline Menu by pressing the key.

2. Press the key or the key until the "Test" menu is displayed.

Press the key to confirm the selection.

3. Select the "Status print" option by pressing the key or the key and

confirm the selection by pressing the key.

4. Start the printout by pressing the key.

5. The "Status print" will be printed with the heat level and the print speed set

in the "Setup" menu.

6. To cancel the "Status print", press the key.

7. Once the printout has completed, the printer returns to the selection list of

the "Test" menu.

The status print contains :

A) the type of printer as well as the version and date of the printer's firmware.

B) the values of selected configuration parameters.

C) cumulative operating time of the printer, amount of printed labels as well as

cumulative length of printed material in direct thermal and thermal transfer

mode.

D) the current values of printhead temperature and heat voltage

E) details about the operation of the sensor used for recognizing the media

front edge

F) a test pattern to display the quality of the print image.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 131 132

Pas de commentaire

Brady THT-BP Precision Manuel de l'opérateur Page 72