Brady THT-BP Precision Manuel de l'opérateur télécharger pdf (Page 9)

9Transfer Printer THT-BP Precision

1. Product Description

Particular Features BP Precision 200P / 300P

The P-versions of the printers are specificly developed for operation in the

peel-off mode and they are equipped with dispense edge as standard. In the

peel-off mode the labels are removed from the silicon liner immediately after

printing, and then available in a dispense position ready for further processing.

A peel-off module, for example an optional present sensor, which is attached to

the printer by the peripheral connector, indicates the presence of a label, and

pauses the printing process until the label is removed. After taking the label

from the dispense position the next label will be printed. To guarantee a

maximum of reliability in the peel-off mode the printers are additionally

equipped with a pair of rollers to cause the dispense tension.

NOTICE !

In the delivery state, BP Precision 200P and 300P are configured in such a

way, that the print speed in the peel-off mode is limited to maximum

100mm/s. When using smaller labels or supply rolls with a small outside

diameter it is possible to increase the print speed for the peel-off mode.

We recommend to carry out preliminary tests with speed limitation

switched off (see printer configuration) !

For the other P-version printers there is no limitation of the print speed in the

peel-off mode.

Characteristics of the Thermal Printhead

CAUTION !

The thermal printhead is the most sensitive part of your printer. Please

pay special attention to the following guidelines:

1) The glass cover on the printhead must not be touched with the hand. Also,

do not use sharp objects (knives, screwdrivers, etc) to clean the printhead.

2) Ensure that the printhead is properly adjusted at all times.

3) Make sure that there are no high spots or debris on your media to lodge on

or damage the printhead. The label surface must be smooth. Lower grade

direct thermal paper is very rough and will act like sandpaper on the head,

reducing the head's lifetime. Do not use low grade stock.

4) Clean the head at each change of ribbon, or with each new roll of direct

thermal media, with a special cleaning pen, or a cotton swab with isopropyl

alcohol.

5) Print with the lowest possible head temperature to increase the life of the

printhead.

6) When changing the printhead, first turn the power off and disconnect the

power cord. Then, place a clean paper towel or tissue under the head to

provide a clean surface for it to rest on. When removing the head, hold it

on the sides only.

Failure to observe the instructions above can lead to a reduced printhead life.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 131 132

Commentaires sur ces manuels

Pas de commentaire

Brady THT-BP Precision Manuel de l'opérateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimantes d'étiquettes Brady THT-BP Precision