Brady THT-BP Precision Manuel de l'opérateur télécharger pdf (Page 57)

57Transfer Printer THT-BP Precision

8. Printer Configuration

Parameter Meaning

Cutter

(Only displayed if the cutter is attached)

Applicator

(Only displayed if the optional applicator

is attached)

Brightness LCD Sets the brightness of the display

Default : 8

Contrast LCD Sets the contrast of the display

Default : 8

Time Powersave Amount of time before switching to

powersave mode

Default : 10 min

Debug mode Activates the debug mode

Default : Off

Selection

1..12

6..11

60 min

...

0 min

Off

Table 8c Overview of the "Machine parameters" Menu (continuation)

Printhead position X

Using this setting will shift the entire print image to the left on the label. This

parameter should only be altered if you are printing the same format on several

printers, and the printed image is not consistent on each printer.

NOTICE !

The value of Printhead position X cannot be greater than the difference of

the printhead width and the defined label width in software. A value

greater than the difference will be ignored and the actual difference will

be used in place. For example, if the printhead width is 104mm and the

label width defined in software is 100mm, the printer will only accept a

value of 4mm or less for printhead position X. If Printhead position X is

set for 6mm, the printer will only shift the label 4mm.

The Printhead position X value to be changed will be flashing on the display.

It is possible to adjust the value for individual jobs using software. The front

panel values and software command values will be totaled together for printing.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 131 132

Pas de commentaire

Brady THT-BP Precision Manuel de l'opérateur Page 57