Brady 1024 Manuel de l'opérateur télécharger pdf (Page 38)

4.5 Label Alignment

The Label Alignment function is intended for applications with short

label lengths that result in wasted labels (between the media sensor and

printhead) when printing the first label after changing media or at power-

up. This is accomplished with providing the printer with a

‘ALIGNMENT LENGTH’ which can be manually measured and entered

(see Section 4.5.1) or automatically calculated using a Forced Alignment,

(see Section 4.5.2). Label Alignment, set via the menu system or via

host commands, has three possible values: YES, AUTO, and NO which

are covered in the following sections.

4.5.1 Label Alignment = YES

In this mode the operator must

supply an ‘ALIGNMENT

LENGTH’ value. The

‘ALIGNMENT LENGTH’ value

is measured from label leading

edge to label leading edge of two

successive labels. This value can

be sent via the host computer or

entered by using the Menu Setup

Mode.

The ‘ALIGNMENT LENGTH’

must be as accurate as possible.

For very small labels, errors as

small as 0.01” could result in

noticeable print variations for the

labels resting between the

printhead and the media sensor.

If media of a different label length

is loaded the ‘ALIGNMENT

LENGTH’ must be recalculated

and changed via the Menu Setup

or host computer.

28 BP-1244/BP-1344

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 81 82

Pas de commentaire

Brady 1024 Manuel de l'opérateur Page 38