Brady THT MVPplus Guide de l'utilisateur télécharger pdf (Page 8)

EN-6 13293LB-12 Rev. 2 16Nov2004 English

Bradyprinter THT MVPplus Quick Reference Guide

Position the Transmissive Sensor

This printer uses two types of media sensors: transmissive and reflective. By default, the

printer uses the transmissive sensor, which you can adjust for optimal print performance. The

reflective sensor is a secondary media sensing system that is activated only if the transmissive

sensor cannot be used to calibrate the media.

The transmissive sensor is equipped with a slide-on sensor sleeve (Figure 4). This sleeve has a

notch on one end and a hole in the middle, which help the printer calibrate media that has an

edge notch or an intra-label gap.

Figure 4 • Transmissive Sensor and Sensor Sleeve

The lower section of the transmissive sensor has two white vertical positioning marks and a

movable adjustment tab pointer (Figure 5). The positioning marks correspond to the notch and

hole in the sensor sleeve.

Transmissive Sensor

Sensor Sleeve

Figure 5 • Transmissive Sensor with Adjustment Tab Pointer

Adjustment Tab Pointer

(Inner Position)

Positioning

Marks

Sensor Sleeve

Adjustment Tab Pointer

(Outer Position)

Positioning

Marks

Sensor Sleeve

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Pas de commentaire

Brady THT MVPplus Guide de l'utilisateur Page 8